Tel No: +44 (0) 1429 836655

sales@fidgeon.co.uk

Family business suppling the Non-Destructive Testing Industry since 1975

Centrifuge Tube (Pear Shaped) Black Ink

£1.00
Product Code: F05.0425

Be the first to review this product

Availability: In stock

£1.00

Details

Particle Concentration
The concentration of particles in the suspension is a very important parameter in the inspection process and must be closely controlled. The particle concentration is checked after the suspension is prepared and regularly monitored as part of the quality system checks. ASTM E-1444-01 requires concentration checks to be performed every eight hours or at ever shift change.

The standard process used to perform the check requires agitating the carrier for a minimum of thirty minutes to ensure even particle distribution. A sample is then taken in a pear-shaped 100 ml centrifuge tube having a stem graduated to 1.0 ml in 0.05 ml increments for fluorescent particles, and graduated to 1.5 ml. in 0.1 ml increments for visible particles. The sample is then demagnetized so that the particles do not clump together while settling. The sample must then remain undisturbed for a minimum of 60 minutes for a petroleum-based carrier or 30 minutes for a water-based carrier, unless shorter times have been documented to produce results similar to the longer settling times. The volume of settled particles is then read. Acceptable ranges are 0.1 to 0.4 ml for fluorescent particles and 1.2 to 2.4 ml for visible particles. If the particle concentration is out of the acceptable range, particles or the carrier must be added to bring the solution back in compliance with the requirement.

Particle loss is often attributed to "dragout." Dragout occurs because the solvent easily runs off components and is recaptured in the holding tank. Particles, on the other hand, tend to adhere to components, or be trapped in geometric features of the component. These particles will be "drug out" or lost to the system and will eventually need to be replaced.

Particle Condition
After the particles have settled, they should be examined for brightness and agglomeration. Fluorescent particles should be evaluated under ultraviolet light and visible particles under white light. The brightness of the particlesshould be evaluated weekly by comparing the particles in the test solution to those in an unused reference solution that was saved when the solution was first prepared. The brightness of the two solutions should be relatively the same. Additionally, the particles should appear loose and not lumped together. If the brightness or the agglomeration of the particles is noticeably different from the reference solution, the bath should be replaced.

Additional Information

Additional Accessories N/A
Product Code F05.0425

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

  • Rohmann
  • Fujifilm
  • Johnson Allen
  • Chemetall
  • Magnaflux
  • Colenta
  • Tracerco
  • Gal Gage Co.
  • Tetenal
  • Radiographic Accessories Limited
  • Vertec
  • High Technology Sources Limited
  • Phoenix Inspection Systems Limited
  • AGFA
  • Wolf Safety Lamp Company
  • X-Rite
  • Balteua NDT
  • Karl Deutsch
This site uses cookies. By continuing to browse this site you are agreeing to our use of cookies. Find out more here.
x